VERY IMPORTANT TO MY BUILD... please help

[Doof]

basically here is what happend in many hours in a few seconds with my front DL

got it finished a few hours ago and put it aside. im swaping out the rear springs right now, as well as putting the new DL on. it is square cutsom stuff, awsome work. but the CV joint is off my stock 86 IFS. it does not have a steep enough angle on it for my new SAS axle. what im asking is what years SA can i pull the CV from to make my DL work. i would like to get this done ASAP. my fingers are still caked in grease from working. i still have more spring to go and i will be back after that is done. so anybody with this vauluable information will be my new hero. thanks a ton

AJ

[Rockcrawlintoy]

just run single joints.

[88v6yota]

a ifs cv driveshaft wont have enough angle but you can modify it so it will

[kneedownnate]

79-85

[binojames]

Just use a SINGLE u joint!!! aj that is all i'm running in my front is 2 single u joints.  i have a cv out of a solid axle toya but needs to be rebuilt and its expensive as hell to rebuild those things.  i don't know if i told you but i tell ppl is to the the cv joint and put that in the rear and use your single u joint from the rear and put that in the front!

[Rockcrawlintoy]

Just use a SINGLE u joint!!! aj that is all i'm running in my front is 2 single u joints.  i have a cv out of a solid axle toya but needs to be rebuilt and its expensive as hell to rebuild those things.  i don't know if i told you but i tell ppl is to the the cv joint and put that in the rear and use your single u joint from the rear and put that in the front!

x2 for sure

[Doof]

thanks guys, that made my night much better


and i just got done with my end lift

[KDXSR5]

 

[binojames]

 

[Doof]

check the bomber build up tomorrow or for the smart  's today

but i just got done working on it and it is time for bed   

[79coyotefrg]

84-85  is the best ,   

[Doof]

i got a rear DL and im gunna use the U joints and what not for the DL

thanks for the info

[Hammerhead]

Yep, run regular U-joints on a square shaft for the front.  In the rear I like to use the front CV with the rear pinion pointed up at 2° - 3° below shaft angle.