square driveshaft

Started by booger1, June 14, 2006, 10:50:56 PM

0 Members and 1 Guest are viewing this topic.

Print
Go Down Pages1
User actions

booger1

June 14, 2006, 10:50:56 PM
I have been searching, but I can't find any threads on how to make a square driveshaft. :flamer:  is it very hard to do?  it is for the front, so I won't have to worry about balancing. 
93 pickup,  sas'd, 36in tsl's, tundra front clip, taco bed, kenwood, apexi intake,  7mgte.

MiniSimp

#1
June 15, 2006, 07:02:16 AM
It's in my build up thead in Rig Gallery

FatAzzRunner

#2
June 15, 2006, 08:39:10 PM
85 Runner, 5" All-Pro Extreme Lift, Complete Marlin T-Case with new TS 4.7 gears, Super Birfields(Longfields), 5:29's, Detroited front, Spooled rear, 36" TSL's, Bikini top.

Yes, Livin in Kansas sucks azz!!

RustyToy

#3
June 25, 2006, 03:07:02 PM
Snot hard,

All ya have to do is get a 2.5 inch seam out square tube about 2 feet long. Get a 2inch seam in square tube about 2 feet long. Put a round peg in some square holes and weld itup.  12 inches of out 3 inches of in.
I'd like to quit thinking of the present as some minor insignificant preamble to something else~~~~~
Print
Go Up Pages1
User actions