Author Topic: so what happens to your truck if you flop or roll??  (Read 4052 times)

0 Members and 1 Guest are viewing this topic.

spaded1

  • Offline Rock Crawl'n
  • **
  • Turtle Points: -7
  • Posts: 102
  • Member since Jan '09
  • 85 toyota pickup EFI, bobbed bed 12 inches, 33'
    • View Profile
so what happens to your truck if you flop or roll??
« on: Feb 03, 2009, 11:30:09 AM »
if you get the engine turned off right away will that help things or just put you in more trouble? ive never flopped or rolled but just in case i gotta be prepared. any tips? :hammer:

79coyotefrg

  • Rock Ninja
  • Offline Gold Turtle Award
  • *
  • Turtle Points: 1452
  • Male Posts: 22,633
  • Member since May '02
  • Solid axle Toys Rule ! ! !
    • View Profile
    • HotSprings Superlift ORV park
that really depends on where you are when you flop
AR-TTORA founder 22R bored.060,LCE stage II race cam http://pure-gas.org/    32/36weber, :driving: Marlin 1200 NON ceramic clutch, L52SHD+dualcase #2919, cable-locker, Yukon 5.29 gears, 35's, Allpro ebrake, front springs, and high steer, F150rears    RIP Nitro 9-29-07 :(  I sure miss him :down: MarlinCrawlerInc IS NOT affiliated with TrailGear in any way

MiniSimp

  • Outdoor Enthusiast
  • Offline Gold Turtle Award
  • *
  • Turtle Points: 0
  • Male Posts: 5,120
  • Member since Jan '05
  • SimpsonBrothers.net
    • View Profile
    • Simpson Brothers Photography
Um, everytime I flop I just keep on the gas and drive out of it, Hyena would be a great person to ask about this, he drives on his roof.

Toymin8r

  • Offline 4WD Legend
  • *****
  • Turtle Points: 50
  • Male Posts: 929
  • Member since Dec '07
    • View Profile
you can keep it running 20-30 seconds without any issues but the oil pickup cant get any oil when the truck goes over.  When you flop it back on all fours give it 10 minutes or so to let the fluids drain back where they're supposed to be before starting it.   You will probably blow tons of smoke out of the exhaust pipe for a few minutes after you re-start it too.
YOU ONLY NEED TWO TOOLS IN LIFE - WD-40 AND DUCT TAPE. IF IT DOESN'T MOVE
AND SHOULD, USE THE WD-40. IF IT SHOULDN'T MOVE AND DOES, USE THE DUCT TAPE.

IF YOU CAN'T FIX IT WITH A HAMMER, YOU HAVE AN ELECTRICAL PROBLEM.


Quote
BeccaLoo24 – i can toss grown men.... so dont doubt me

All_Set

  • Offline Crawler Guru
  • ****
  • Turtle Points: -145
  • Male Posts: 543
  • Member since Mar '04
    • View Profile
    • Blue Ribbon Coalition
What toyin8r said.

TO add, to be safe, pull the plugs before cranking as oil tends to find its way into the cylinders.  If enough finds it way in you chance a hydro lock situation.  Stand back from the plugs as oil will get everywhere.  Once oil is out of the cylinders, put them back in, and attempt to fire. 

Oh, battery better be 100% secured too.  Best way to burn up a truck, fall on your side/top, arc out, and light up that oil/gas thats dripping from everywhere!

Pick up 100% of your yard sale!  :D



If you would like to help save the Rubicon, send money to the Rubicon Trail Foundation

jimbo74

  • Offline Gold Turtle Award
  • *
  • Turtle Points: 2872
  • Male Posts: 8,707
  • Member since Sep '05
    • View Profile
replace any of the fluids your truck just dripped all over the place, check all fluid levels
:usa:

The cost of freedom is always high, but Americans have always paid it. And one path we shall never choose, and that is the path of surrender, or submission.

~ John F. Kennedy ~

YouBet

  • Offline Rock Master
  • ***
  • Turtle Points: 0
  • Male Posts: 182
  • Member since Nov '07
  • 85'n it!
    • View Profile
When mine went over on the driverside  it ran for about 10sec before I could get it off. Sat on its side for about 20min before we could get it righted. Fired right up with out any problems. Pulled out the spray paint, touched her up, and good as well not new but, as good as it was.
'85 p/u, 38 15.5 TSL radials, Duals, Welded IFS Rear, Chevy 63's rear, 2.5" wranglers up front, MP's front bumper & sliders, Exo,Winch, 5pt harness', Hy steer power steering convers.,Bed cage, Sweet custom rattle can paint job.

unclejpl4x4

  • Offline Silver Turtle Award
  • *
  • Turtle Points: 348
  • Male Posts: 3,522
  • Member since Apr '05
  • Broke & rusted
    • View Profile
    • myspace
    • Buy me a beer
 1. shut motor off if U can't save it.
2. assume the roll over position  ( brace your legs in the corners hold the wheel firmly) and yell a few words of meaning.
3.  I would allways pull the plugs.
4. clean up and mess U might have on the ground or in your pants ( spill kit)   
build thread http://board.marlincrawler.com/index.php?topic=39214.0
CB install http://board.marlincrawler.com/index.php?topic=45467.0
roundeyes http://board.marlincrawler.com/index.php?topic=33294.0;highlight=round+eyes
LC exhaust head 2 tip, EB RVstreethead O/S valves,EB  268c/torker cam , .20 over , metal t-chain wear pads
MARLIN clutch 1200, master clutch cly

Hyena

  • I'm Legit!!!
  • Offline Gold Turtle Award
  • *
  • Turtle Points: 2401
  • Male Posts: 6,715
  • Member since Feb '04
  • AKA Baja Brad
    • View Profile
if it is on its side then try and drive out of it.  most of the time my motor just dies though even though it is a 22re.  when i get it over i hit the starter button real quick to tell of the motor wants to turn over (to make sure there is no oil in cylinders)  if it cranks freely then start it up.  it will smoke for a bit but will be ok.  if it doesn't crank good then pull the plugs and close the hood.  also pull the distributor wire.  crank it over till no more oil come out of the plug holes.  check the gaps on the spark plugs to make sure they didn't get smashed from the compression of the oil (happened to me once)  put them back in and drive away!  don't forget to clean up your mess too.

93yoda

  • Offline Rock Crawl'n
  • **
  • Turtle Points: 7
  • Posts: 24
  • Member since Dec '06
    • View Profile
To answer you question directly..... you will get body damage...  :yesnod:and your butt will most likely pucker.

66cobra

  • Offline Rock Master
  • ***
  • Turtle Points: 34
  • Posts: 251
  • Member since Mar '08
    • View Profile
toyotas fold like a cheap suit i highly recommend a roll cage
it's not me, it's you

Steve_925

  • Offline The 1.5K Club
  • **
  • Turtle Points: -86
  • Male Posts: 1,876
  • Member since Feb '07
  • F***in catalina wine mixer
    • View Profile
every time i flop my first instinct is to shut the engine off. one time i flopped at hollister, started seconds later let out the clutch and it died, then it hydro locked with oil. deffenatly after you pull the plugs and cap wire shut the hood. i had oil dripping off my face because i didnt do that. i also laid it on its side going up a crevise at moon rocks, it stayed running for about the 20 min it took me to drive it out. just make sure your eye is on the oil pressure.
1973 HILUX build up-------> http://board.marlincrawler.com/index.php?topic=48133.new#new


UA 342
STEAMFITTERS

4RunnerChevy

  • Offline The 1K Club
  • *
  • Turtle Points: 5
  • Male Posts: 1,426
  • Member since Sep '08
  • Santa Cruz Mountains
    • View Profile
    • Santa Cruz Wheelers
I flopped my runner on its passenger side.  The 4.3 kept runnin, cause my keys came out of the ignition, and fell out the passenger window  :ha_ha:

unclejpl4x4

  • Offline Silver Turtle Award
  • *
  • Turtle Points: 348
  • Male Posts: 3,522
  • Member since Apr '05
  • Broke & rusted
    • View Profile
    • myspace
    • Buy me a beer
I flopped my runner on its passenger side.  The 4.3 kept runnin, cause my keys came out of the ignition, and fell out the passenger window  :ha_ha:

:psss: seat belts save lives,   we have seen fellow wheeler killed this way :down:
build thread http://board.marlincrawler.com/index.php?topic=39214.0
CB install http://board.marlincrawler.com/index.php?topic=45467.0
roundeyes http://board.marlincrawler.com/index.php?topic=33294.0;highlight=round+eyes
LC exhaust head 2 tip, EB RVstreethead O/S valves,EB  268c/torker cam , .20 over , metal t-chain wear pads
MARLIN clutch 1200, master clutch cly

4RunnerChevy

  • Offline The 1K Club
  • *
  • Turtle Points: 5
  • Male Posts: 1,426
  • Member since Sep '08
  • Santa Cruz Mountains
    • View Profile
    • Santa Cruz Wheelers
I flopped my runner on its passenger side.  The 4.3 kept runnin, cause my keys came out of the ignition, and fell out the passenger window  :ha_ha:

:psss: seat belts save lives,   we have seen fellow wheeler killed this way :down:

Yes they do, and yes we were wearing them, thanks!

unclejpl4x4

  • Offline Silver Turtle Award
  • *
  • Turtle Points: 348
  • Male Posts: 3,522
  • Member since Apr '05
  • Broke & rusted
    • View Profile
    • myspace
    • Buy me a beer
o ok i miss read i thot U went out the passenger window  " the keys went out the window"  :slap:
build thread http://board.marlincrawler.com/index.php?topic=39214.0
CB install http://board.marlincrawler.com/index.php?topic=45467.0
roundeyes http://board.marlincrawler.com/index.php?topic=33294.0;highlight=round+eyes
LC exhaust head 2 tip, EB RVstreethead O/S valves,EB  268c/torker cam , .20 over , metal t-chain wear pads
MARLIN clutch 1200, master clutch cly

emsvitil

  • Offline Silver Turtle Award
  • *
  • Turtle Points: 7571
  • Male Posts: 3,561
  • Member since May '07
    • View Profile
    • emsvitil's album
    • Buy me a soda
You

 :rivers:
Ed
SoCal
86 SR5 XtraCab
22RE  W56B
31x10.50R15

4RunnerChevy

  • Offline The 1K Club
  • *
  • Turtle Points: 5
  • Male Posts: 1,426
  • Member since Sep '08
  • Santa Cruz Mountains
    • View Profile
    • Santa Cruz Wheelers
o ok i miss read i thot U went out the passenger window  " the keys went out the window"  :slap:

 :laugh:





OldGold3VZE

  • Offline Crawler Guru
  • ****
  • Turtle Points: 4
  • Male Posts: 417
  • Member since Feb '08
  • Run whatcha brung, and have some fun!
    • View Profile
    • Light Racing, High Performance Bump Stops
My 1980 Long Bed build thread
http://board.marlincrawler.com/index.php?topic=84562.0

Truggy build thread
http://board.marlincrawler.com/index.php?topic=89844.0

Rastafari Livity!  Ital = Vital!

 
 
 
 
 

Related Topics

10 Replies
3193 Views
Last post Nov 26, 2003, 07:06:37 PM
by yodaboy
16 Replies
4974 Views
Last post Oct 09, 2005, 04:27:44 PM
by Rocksurfer
6 Replies
2481 Views
Last post May 26, 2007, 08:43:14 AM
by KYOTA
22 Replies
4562 Views
Last post Apr 17, 2008, 02:59:19 PM
by BLACKDOG
12 Replies
3730 Views
Last post Jul 29, 2008, 08:04:11 PM
by madmanweaver444