Topic: frame sleeves for sas

[muddenyota]

any one have pics of which way they sat the jigs in there

[OOPS]

any one have pics of which way they sat the jigs in there

What do you mean? They go in from the bottom.

[Steve_925]

i think he might meen wich way to point forward and where to place it (pushed to the front of the body mount or to the rear.) all i can say is that if you mount your front hanger pretty far forward you want to push the jig farther forward than told. my hanger is 3/4" forward of the x member and i put the frame slugs where it was recommended but since i whent that far forward with the hanger i now have a bad shackle angle. they point straight up and down, it limits my droop a bit. just my

[Hyena]

you put them in so they are aligned with each other.  i like to push them forward to the front of the body mount and then adjust the front hanger for a good shakle angle.

[91 super yoda]

i put mine right in the middle with excellent shackle angle on 4" springs and the hanger centered on the front x-member.

[muddenyota [OP]]

you put them in so they are aligned with each other.  i like to push them forward to the front of the body mount and then adjust the front hanger for a good shakle angle.

sounds like this is what i'm gonna do  thanks for some good advise 

[tryn2Crawl]

i like the underframe mount..I dont like the shackle and frame touching issue..but thats just me..

[sabenson82]

i like the underframe mount..I dont like the shackle and frame touching issue..but thats just me..

I AGREE!!