Topic: Message #702456

[Snowrunner]

Got some work done tonight and some more parts to show off.

Here is the radiator that im going to use. Its a summit racing 22x19x2.25 Cross Flow Dual Row part#SUM-380324. Got it for 170 shipped to my door. Its the perfect radiator for any toyota conversion because even though its listed as being bigger than a stock radiator it is the same size. Just weld some tabs on the side and bolt it in in the stock location.




Got the motor mounts done and all tacked into place. Just need to make some small pieces to brace it up and finish weld it. I know that its cocked to the driver side a little. This is due to positioning the headers and to bring it over just a little from the center section. Its a tight fit but I think I got it right where it needs to be.







I also got my front axle set where I want it. It has 7* of caster and the pinion points almost right at the tcase. When I get my duals in there it should be perfect. Just need to get the steering box mounted and extend my tierod and drag link and the steering will be done too.