Topic: 5.29 thirds/elocker/dual case adapter/dshafts

[toyotaboy]

looking for two 5.29 8" toyota thirds. would like one to be an elocker if possible but would consider other lockers as well. no lunchbox. dual case adapter needed as well and drives hafts for a third gen extra cab 22re 5spd with duals. need asap for a truck im building for my brother in the army.

[toyotaboy [OP]]

well got the thirds done, got the duals done, still looking for some drive shafts if anyone's got some

[crazykooter]

Drive shafts are best made by measuring and then having one made.  For the front I would buy a marlin extended long spline shaft.  For the rear I would get a heavy duty shaft built out of like .120 wall and have a cv installed and balanced.  In the long run it will save ya money since stock drive lines dont hold up that well when on the trail.
If you were closer I could make you one but your a bit away from me.