0 Members and 3 Guests are viewing this topic.
hi im putting the marlin 4" lift (5" springs in rear) and dual cases under my 4runner. i was gonna buy a front drive shaft from someone that was for a dual case set up and h said it has 6" of slip, but im also going to be running a hp elocker up front so would that add some extra slip to it and if so would that be enough to keep my shaft from disconnecting when im flexin?
build a square one
BeccaLoo24 – i can toss grown men.... so dont doubt me
Square driveshafts belong in the Fontucky fab section, I would't recommend it.
Hey Steve you gonna follow my lines at Flatnasty in a couple weeks?
toyminator2000 – There has to be dumb people in order for there to be smart people
Yea, it wont be hard to follow! We can hear your square shaft clanking from the other side of the park jk (kinda)
Thats a pretty strong statement. I'd put my square shaft against a round one, implement, or profeshionally built, any time strength wise! Square round or triangle , it really is a matter of opinion.
Check out this thread. This is what can happen with a square driveshaft.http://board.marlincrawler.com/index.php?topic=45495.0
i made my shafts myself for the cost of a new cv kit $30 and a box of 6011 rods
do you have a picture of ur shaft?
wow way to twist my words..... im 17 and i dont even do that.....
32 going on 17 here! I was just joking around with ya bud
Started by wifesaysimadumbass Toyota Pickup/4Runner Tech 1979-95
Started by 8D3TOY For Trade or Barter!
Started by rockin86runner Parts Wanted
Started by tom85 Project Research and Build-Ups
Started by desrodunes1 Parts For Sale