Topic: Another Bottom Knuckle Pin Question?

[RTA]

Does anyone know what kind or wear this bottom knuckle plate/pin comes from?  It has an offset pin and stamped on the bottom for positive/negetive adjustment to flip 180*.  Also stamped on bottom "INGALLS 700 TOYOTA 4X4 PART#C-3/4 PAT. PEND". 

[79coyotefrg]

thats some crazy aftermarket  adjustment  cap  for  either a bent housing  or a busted bearing  that should have been replaced instead of a bandaid fix like that

[79coyotefrg]

thats not the one i sent you 

[RTA [OP]]

thats not the one i sent you 

No, its the one in the other side.  I had those type on my truck since I got it. I thought they were stock until now. Just wondering if anyone else has come accross any of them?

[DTB]

I've never seen anything like that....google search netted zippo

[WHITE_TRASH]

I got a bent housing from a junk yard once with smaller upper trunion bearings.  The race was offcenter from the outer so depending on how you put the race it it would adjust the camber.  Last I heard les schwab's could get them for $100 each.....

[OOPS]

Aftermarket plate for adjusting the camber is my guess. Sort of hokey looking.

I bet they were made by this company at one time;

http://www.ingallseng.com/index.html

[RTA [OP]]

Aftermarket plate for adjusting the camber is my guess. Sort of hokey looking.

I bet they were made by this company at one time;

http://www.ingallseng.com/index.html

 

Yes, I just got off the phone with them.  They do not make them anymore.  They made 3 different offsets 1/4",1/2",3/4".  They might have some packed away in their shop.  I asked for some more info and history on them. How many they might have sold, when they stopped making, ect. Someone is going to get back to me on it...