Author Topic: engine won't restart  (Read 1706 times)

0 Members and 1 Guest are viewing this topic.

Johnny5

  • Offline Rock Crawl'n
  • **
  • Turtle Points: -16
  • Male Posts: 62
  • Member since Dec '04
  • Crawling with Marlin
    • View Profile
engine won't restart
« on: Apr 16, 2006, 04:14:03 PM »
i have an 87 4runner that i just swapped in an 88 motor. i swapped thye engine wiring harness in with the motor. i can start the motor runs great, take it for a drive, drives fine, shut it off and restart it no problem. the problem is if i let it sit for a couple hours it won't restart just kicks. seems to be getting fuel and spark. ran great in donor truck but has a new timming chain and sprockets and head gasket when swapped . motor is timed right. will fire right up if sat overnight . just lookinfg for other ideas??? sorry for the long post.

thanks john

Trunkz

  • Offline Rock Crawl'n
  • **
  • Turtle Points: 79
  • Posts: 45
  • Member since Sep '05
  • Crawling with Marlin
    • View Profile
Re: engine won't restart
« Reply #1 on: Apr 16, 2006, 10:00:41 PM »
check your grounds... sounds wierd.. but its something to look for

rexandfx

  • Offline Rock Crawl'n
  • **
  • Turtle Points: -7
  • Male Posts: 50
  • Member since Oct '05
  • hill-billy ramp travel
    • View Profile
Re: engine won't restart
« Reply #2 on: Apr 17, 2006, 05:56:19 AM »
I have the same problem with my 86 turbo runner, after an hour or 2, mine is a really hard start, it will fire, then die immediately. It takes about 7 or 8 times and then mine will start.
But, after sitting overnight, no problems.

I initially thought, dirty or just plain worn-out injectors. :dunno:

Good luck on your fix, if you figure it out, let us all know. :thumbs:
86 4runner 22rte- stock...for now
81 jeep cherokee widetrack fullsize- also stock...for now

UGLYTOY

  • Offline Rock Crawl'n
  • **
  • Turtle Points: 0
  • Posts: 38
  • Member since Dec '05
  • Crawling with Marlin
    • View Profile
Re: engine won't restart
« Reply #3 on: Apr 17, 2006, 06:28:55 AM »
there is a tsb for something like this, but i don't think it's on the 88's--look into the coolant temp sensor and the cold start injector time switch, they upgraded those in some way for a similar problem.....just another thought

86turboyota

  • Offline The 1K Club
  • *
  • Turtle Points: 0
  • Male Posts: 1,079
  • Member since Jul '05
  • Crawling with Marlin
    • View Profile
Re: engine won't restart
« Reply #4 on: Apr 17, 2006, 01:02:50 PM »
coil/distributor
My Build 1986 4runner SAS 36s etc
http://board.marlincrawler.com/index.php?topic=22625.0

"Later, I learned that even though I engage 4WD my hubs are not automatically locking? Something about manual locking hubs I think. What's manual mean? I need to read a manual to lock them? lol  So I found these neat autolocking hubs and installed them. Sometimes they dont stay locked while I am backing up, but that's fine because I dont have a backup camera to see where Im going (like our RV) so I just simply dont ever back up"- BigMike

Johnny5 [OP]

  • Offline Rock Crawl'n
  • **
  • Turtle Points: -16
  • Male Posts: 62
  • Member since Dec '04
  • Crawling with Marlin
    • View Profile
Re: engine won't restart
« Reply #5 on: Apr 17, 2006, 04:14:41 PM »
checked grounds, changed coolant temp sensor and cold start switch, tryed another computer. 88 motor does not have sensor on top of thermostat like 87 but i used the 88 wiring harness so the only other differnce is 88 motor 02 sensor is down by the cat where the  87 is in exhaust manifold(which i used because that part of harness is hooked to the dash). the 87 motor works good put back in the donor truck though???

Johnny5 [OP]

  • Offline Rock Crawl'n
  • **
  • Turtle Points: -16
  • Male Posts: 62
  • Member since Dec '04
  • Crawling with Marlin
    • View Profile
Re: engine won't restart
« Reply #6 on: May 07, 2006, 03:04:05 PM »
tried changing fuel pump, mass air, coil, distrib still same problem. figured out if you pump throttle will restart after a couple of cranks. once going motor runs excellent.

Bazzi

  • Offline The 1K Club
  • *
  • Turtle Points: 97
  • Male Posts: 1,095
  • Member since May '04
  • From Reykjavik Iceland...
    • View Profile
    • R&T
Re: engine won't restart
« Reply #7 on: May 07, 2006, 05:06:09 PM »
air flow sencor ??? wierd but I bet it is something real silly.
have heard about this before but canīt put my fingure on it what the deal was?

good luck
4runner body on a hilux frame = Hi-Runner.
 2,4 dti duals 2,28 x 2,28 to 8" 5.71 with arbīs  and 39,5" trxus
gathering parts for my goal which is
350 Chevy 700r4 auto to 2.28 x 4.70  and 4.88 9,5" cruisers diffs,diamondaxles and cable lockers, 44" richard cepecs

 
 
 
 
 

Related Topics

11 Replies
3256 Views
Last post Jul 25, 2003, 02:20:55 PM
by gferris5
2 Replies
1836 Views
Last post Aug 18, 2002, 09:12:26 AM
by Benge Scott
3 Replies
1633 Views
Last post Jan 15, 2004, 12:42:04 AM
by Snowtoy
2 Replies
1187 Views
Last post Apr 21, 2006, 06:36:52 PM
by Jase
10 Replies
8363 Views
Last post Feb 08, 2010, 09:09:34 AM
by steveco.