hy pinion (front)

Started by mr4x42u, April 24, 2003, 12:10:31 AM

0 Members and 1 Guest are viewing this topic.

mr4x42u

whats needed for a hypinion set up for the front end?reverse cut gears and oil slinger all thats needed?? :scratch:
Forgiveness is between them and god..
Its my job to arrange the meeting!

79coyotefrg

#1
yea  :.order:thats a good question :dunno:
AR-TTORA founder 22R bored.060,LCE stage II race cam http://pure-gas.org/    32/36weber, :driving: Marlin 1200 NON ceramic clutch, L52SHD+dualcase #2919, cable-locker, Yukon 5.29 gears, 35's, Allpro ebrake, front springs, and high steer, F150rears    RIP Nitro 9-29-07 :(  I sure miss him :down: MarlinCrawlerInc IS NOT affiliated with TrailGear in any way

hawaii500_1999

#2
i think they run a differnet third member housing as well.
cause the ring gear needs to be offset to the oposite side.

i thinkit's from some year of cruiser.  i don't know.

wasn't there somone in the for sale section selling one a while ago?
1985 4runner on 35 boggers.  22re, W56 tranny, daul cases with 4:1 in the back case, ford f150 fronts with 63" chevys in the back, cross over steering, full width chevy axles with detroit back and ARB front,

mr4x42u

#3
Yea..i remember seeint it for sale but did not ask about it...
Forgiveness is between them and god..
Its my job to arrange the meeting!

cgbemis

#4
You need a complete highpinion front diff from an FJ80 land cruiser. It has special gears, and oil slinger,and  a special housing. I believe the bearings are from a v6 diff., and a locker from a v6 diff should be able to work in it as well.