Topic: help me id this tranny...

[krawler76]

what modle is it..

[b-radhutch]

what did it come out of?

[krawler76 [OP]]

a 88 4runner but not the og set up...the og was v6 stuff

[79coyotefrg]

looks like a w56 c or d

[krawler76 [OP]]

thought maybe a g series....

[freds40]

I'd say a G52 or G54 as the forward shift W series have a 6 bolt shifter base that has both the trans and t-case shifters on the same base. The G series use 2 seperate plates. Also, I would suspect it's not an R as the detents for the trans shifter on your trans are more towards the back where the R series detents are more towards the front. Your drain plug should go straight down and not to the passenger side as the R series trans does.

[abnormaltoy]

thought maybe a g series....

I just want to thank you for putting that avatar back up! 

[79coyotefrg]

I'd say a G52 or G54 as the forward shift W series have a 6 bolt shifter base that has both the trans and t-case shifters on the same base. The G series use 2 seperate plates. Also, I would suspect it's not an R as the detents for the trans shifter on your trans are more towards the back where the R series detents are more towards the front. Your drain plug should go straight down and not to the passenger side as the R series trans does.

you could see that in THAT pic

[Rocksurfer]

Since it is a forward shift and out of an 86, that tells me it was a carburetor 22r truck which makes it a G-54 If it were an EFI 86 it would have been a W-56B.

Now if it came out of a turbo truck it would be the R151F and is a real keeper, both the 22r and the 22RTE have forward shift t-cases.

[freds40]

you could see that in THAT pic

Yup.
It's definitely a G series. If it's original to the truck it should be a G54. If theres a chance it's been swapped then the numbers would have to be checked or the nose cone would need to be pulled to measure the input bearing.