Decided to start the weekend early and started working on the lower rail for the flatbed.
The basic shape of the rear.
Mocking up the corner. I used the magnets to hold the pieces in place instead of tack welding them on so it would come apart easy for using them for patterns for the other side.
I cut a triangle section out of both side of the end of the 1 1/2" tube to slope the top of it down to where it runs into the 1” tube.
This weekend I'll do the other corner and the rest of the rear. Then fully weld it up and moving on to the lower rails in front of the tires and then sheeting it if I have enough time.
