Ya I plan on cutting them at the level right below where the fender flare is. I am trying to keep this truck looking somewhat stock I guess. Like not trimming the flares out and bobbing bed ect. Well see how it looks with it cut and the new support pieces put in.
What do yall think of the design ? Is it funky ? I went for something way diff. I am gonna get a piece of plate and cut it the deminsion of the center part above the lower bar and then take it down and have TOYOTA cut into it. I think that would look wicked. Well see.
Ok I am off to go put my sliders on. One side is welded up just need to get it welded to frame and other still needs to be cut.
Not sure if I should gusset the supports or not. Not sure I am gonna be doing too serious of wheelin to be on them too much.
