well im sure some of you seen my post about the thrust washers/bearings, well 5 minutes down the road the motor went. so now i pulld the motor and i can try and fix this dang noise to. its only gotten worse since i first posted it. now its just a horrible squealing noise the whole nieghborhood can hear when ever i touch the clutch pedal.
when i put the 5 spd in, i used the same clutch and flywheel that its been mated up to. inlcuding the fork and everything, i did reuse my slave cylinder tho. only problem i noticed was mine was about a quarter inch to long so i just cut it down and it fits perfect.
im not sure on what you mean on "realease bearing" im assuming its the throw out bearing, i installd it the same way the old one was. i lookd for writing but couldnt see any. one side is kind of rounded and the other side isnt...the rounded side is against the clutch... should i go ahead and try buying another one, maybe a more expensive one.
also when i removed my starter, i noticed the flywheel has been grinding on it a little bit.