Topic: Message #596140

[KDXSR5]

Ok, I finally finished my bumper install.


As you can see, the hole does not line up on this tab on my bumper. It is the same situation on both sides. I used a soapstone metal marking device to draw where I needed to cut out:






I cut it out using a drill bit and a lot of time. It took FOREVER to get both sides done (notice the body mount is taken out and the small bolt on the leaf spring hanger setup is removed so I wont damage them):




A bolt now fits (This is obviously not the bolt from my Marlin bolt kit, I lost those. These bolts are rear shock mount bolts off of a 1990 toyota. They work perfectly):