I rarely get to watch it, but when I do, I'm in stitches the whole 1/2 hr. Good stuff.
Now I'm trying to find some 2 3/8" O.D. 0.120 tubing to sleeve the inside of my outter tube of my front axle so I can get this outter seal from Parts Mike to fit (wheew!!!). Apparently I have some thin wall axle tubes .250 wall and they don't make a seal for that inner diameter. 2 1/8 is what I have, and their next size up fits 2 1/2" and up I.D. SOOOO, I have to silicone a sleeve into the tube to get the smaller one to fit.
