« on: Jan 30, 2004, 11:21:53 PM »
Thanks again, gferris
We sell a two hole boot with our twin stick kit that would seal your twin stick shifter. I think we sell it for $20-25.00.
You will need to cut your factory boot in two, and keep the trans boot in the factory location.
I belive a peice of sheet metal could be used to mount the twin stick boot in place.
I have not had the opportunity to install a twin stick in the factory location.
Marlin
Logged
1980 Toyota - 1997 3RZ-FE 2.7l Engine, Turbo R151F 4.31:1, Triple Turbo Marlin Crawler Billet (2.28x4.70x4.70) = 1,148:1 Crawl Ratio, Marlin Crawler Twin Stick and Short Throw Shift Kits, 30mm H/D Output Shaft, High Angle Drive Lines, 5.29:1, ARBs, High Pinion Front, 25mm HD Billet High Steer Kit, 6 Pin Locking Hub Bodies, 86+ Wide Rear End, V6 3rd member, Chromolly Axles all around, 37" IROKs with Beadlocks, York onboard air - Rollbar air tank, Premier Power Welder, Marlin Crawler 4" USA-made Leaf Springs, Bilstein Shocks, et cetera....