a friend picked me up a couple fiber glass tanks for dirt cheap at a swapmeet.
![](https://i835.photobucket.com/albums/zz276/crawle/3_zpsl3mdkmbc.jpg)
had the parts to make a antiwrap bar laying around for some time, so i finally made it. made it as long as i could without making a new crossbar and cutting out the stock one. ended up four foot long.
![](https://i835.photobucket.com/albums/zz276/crawle/bar_zpsnr3zhxr5.jpg)
![](https://i835.photobucket.com/albums/zz276/crawle/extend_zpsfzrclu0w.jpg)
a little hard to see but i platted the sheet metal housing before i mounted the mounting plates.
![](https://i835.photobucket.com/albums/zz276/crawle/double%20plate_zpsbhbotbvr.jpg)
found that my rear ubolts where loose and the spring bolts toast.
![](https://i835.photobucket.com/albums/zz276/crawle/bolt_zpsbwptawdw.jpg)
checked the fronts and they where good but found the passenger motor mount was broke. so i cleaned it put and welded in a 3/16 plate.
![](https://i835.photobucket.com/albums/zz276/crawle/ear_zpsqvjwjaci.jpg)
![](https://i835.photobucket.com/albums/zz276/crawle/passenger_zpsfk5k7log.jpg)
the driver side is starting to go, most likely because of the torque on it with out the passenger mount helping.
![](https://i835.photobucket.com/albums/zz276/crawle/driver%20m_zps5f7m3umw.jpg)