Well got the driveshaft bolted in, the trans and cases filled with fluids, and the shifter hole cut out. Pretty much got everything mounted, just need to make something to screw down the rear case boot. I also didn't finish buttoning up the front shifter boots because i need to order a shifter seat/bushing for the trans because mine are long gone.
On a side note, does anybody know where the wires for the reverse light are supposed to tie into the harness? The harness that comes down to the trans only had plugs for the electronic speedo, 4wd indicator light, and the o2 sensor. i even unwrapped a lot of the harness to try to find if the wires had gotten pulled out from somewhere and cannot find that anywhere. (the plug for the reverse light was not plugged in when i got the truck, and apparently it and the wires that go to it are missing).
