working on the install of the dual transfer case and budbilt crossmember.
I have the Radesign triple sticks which I will be installing. While I was under the vehicle cleaning up some rust I found that the rear heater lines were totally pooched. Sprung a large leak while wire brushing. As well, with the triple sticks and Allpro driveline brake , it doesn't look like I will be able to safe the rear heater.
I am in the process of mounting the dual transfer case with the crossmember. Not sure how much cutting of the floor I will need.
Anybody else use the Radesign on a 1st gen 4runner without a body lift and the allpro transfer case brake. . How much of the floor needs to be cut out?
I have cut out a number of spacers to lower the crossmember 1/2 inch to give a bit more room.