Topic: knuckle ball rotation

[axled89]

wasn't there a write up on this subject??    i searched but didn't find nothing that helped.     i found 1 thing that led no where.  please 

[86bobbedtoy]

mark them
cut them
turn them your desired radious
weld on

not a big deal
the excessive heat can warp the housing tho
and remember heat pulls, so tack them in a side to side motion before doing the finish weld

[axled89 [OP]]

i got the jist of it but there was a write up on it some where.   on how to do every thing start to finish.
       and there was more to it then that i thought.

[<MIKE>]

my buddy used a pipe cutter on his. he made two etch marks on the cut and uncut side then tac'd one at the desired angle. then measure the gap between the two marks so u can make the other side the same. then just put your new perches on.  it wasn't science or anything but it seems to work for him.

[86rustbucket]

i think the hard part is the passenger side spring perch cause it sits halfway on the pumkin