Author Topic: Hydro assist on the cheap  (Read 220520 times)

0 Members and 1 Guest are viewing this topic.

Volcom

  • Offline The 2K Group
  • ***
  • Turtle Points: 269
  • Male Posts: 2,394
  • Member since Sep '04
  • Colorado Rocks!
    • http://www.rockfrogs.org
Re: Hydro assist on the cheap
« Reply #420 on: Feb 11, 2011, 07:37:22 AM »
Thanks  for the write up, lots of info. One question I have is how do I know where to weld the mounting tabs on the tierod so the cylinder travels equally in both directions?

Turn the steering whee so the tires point straight forward.  Take your ram and pull it out so that half of the ram's travel is showing.  Most use a 6" ram so make sure 3" of chrome rod is showing.  Make sure your passenger side mount is as far over to the passenger side as possible.  I made that mistake once and ended up bending the frame, bump stop brackets, bending a tie rod, and busting the chrome rod out of the ram.  Once I got everything fixed, I mounted it closer to the passenger side U bolt plate





84 4Runner
Swapped EFI and a rebuilt 22RE
Marlin Dual Ultimate crawler
Marlin high steer
TG springs
5.29's, Aussie locked front and rear
39.5" Iroks on 15x10 2.5" backspaced wheels
109" wheelbase
Addicted Off Road 8 point cage
Addicted Off Road front bumper

Addicted Off Road

Colorado Marlin members, check out the Colorado section!!!

 
 
 
 
 

Related Topics

4 Replies
2500 Views
Last post Mar 31, 2005, 10:26:44 PM
by freds40
409 Replies
246412 Views
Last post Oct 10, 2018, 11:36:56 PM
by epantano
4 Replies
2166 Views
Last post Dec 04, 2005, 08:01:14 PM
by KYOTA
0 Replies
1242 Views
Last post Jan 29, 2006, 08:52:12 PM
by KYOTA
1 Replies
1777 Views
Last post Feb 27, 2008, 11:21:02 PM
by robrub00