0 Members and 4 Guests are viewing this topic.
toyminator2000 – There has to be dumb people in order for there to be smart people
no i had a rubber strap to keep it from falling in the engine. and the hood was keeping it from jumping out. yeah
drilling out the pop rivets sounds like a good idea. i can weld, just not very good. so if i can find another box and remove it without too much damage maybe i could weld it back in.
haha I kinda figured you did The only reason I say that is that I've seen a battery jump into a radiator fan and kill the engine
BeccaLoo24 – i can toss grown men.... so dont doubt me
My current battery tray is an angle iron frame, welded to the factory location, with a small brace/clamp type pice on each side, to prevent it from sliding in any direction, or floping up, or down.
Please....whatever you do..dont use a bungie cord to hold it down...I see that too often 'round here
Started by SWAMPER General 4WD Discussion
Started by oddball Project Research and Build-Ups
Started by notajeep General 4WD Discussion
Started by Ramrod « 1 2 3 » Chit Chat Camp
Started by jrock Engine