Topic: Need toyota EFI stuff

[MR_DIY]

I am thinking about an EFI swap almost immediately.

I need everything from an 83-84 Toyota Celica or Pickup (2x4 or 4x4). 

would prefer an entire engine, but this is what I have to have

Head, harness, intake, ecu, and camshaft if good.

leads to junkyards etc... would also be appreciated

[80crawleryota]

if you were in california i have an 83 celica that runs with efi, i would sell for $500 with title

[rocblaz]

u can still use your head. i still used my carb head and cam when changed to efi was a bolt in swap.to far away to help calif .

[MR_DIY [OP]]

I knew there would be tons of cali' folks... I'll keep looking... thanks

[4xtoy]

I've got a good used stock cam and a air flow meter for a 22re.  $40 + shipping for both.

[MR_DIY [OP]]

thanks.. I have a few pending deals for it all.  I'll  post up

[billy hill]

If your leads fall through. I have everything you need (minus the head). Intake (started to polish) computer (86 4x4 auto) complete harness, etc. I live in Mo., so shipping might be a little pricy. But I'd sell for cheap.

[MR_DIY [OP]]

If your leads fall through. I have everything you need (minus the head). Intake (started to polish) computer (86 4x4 auto) complete harness, etc. I live in Mo., so shipping might be a little pricy. But I'd sell for cheap.

the ecu being auto?  would that matter? 
I pm'd you. thanks

[mudmaster]

the ecu being auto?  would that matter? 

It does. I've got an intake and ECU from an 84 Celica but I'm in WA

[BUBBA]

I've got a complete motor,tranny,tcase.engine harness and computer included.

[MR_DIY [OP]]

I've got a complete motor,tranny,tcase.engine harness and computer included.

too much money.. thanks though.
I need to figure out if it's just a faulty throttle cable or something else (throttle shaft worn out? )

I'll know tomorrow hopefully.  gotta finish the stupid dual case install *problematic one* so I can test each possibility on a hill. 

[billy hill]

I swapped out cabs on my truck a while ago, The cab I use now is from an 87 2x4 automatic. I just jumped the wires that go to the transmission. So I think that you can get it to work.

[MR_DIY [OP]]

I swapped out cabs on my truck a while ago, The cab I use now is from an 87 2x4 automatic. I just jumped the wires that go to the transmission. So I think that you can get it to work.

can anybody verify this?  thanks

[hornett22]

where are you at?