Author Topic: Toybrota's 22R build  (Read 47405 times)

0 Members and 1 Guest are viewing this topic.

Toybrota

  • Offline 4WD Legend
  • *****
  • Turtle Points: 166
  • Male Posts: 760
  • Member since Dec '15
  • Crawling with Marlin
    • View Profile
    • Buy me some coffee
Re: Toybrota's 22R build
« Reply #510 on: Apr 14, 2019, 06:33:22 PM »

Yes stock intake and plate. Hope your next try works.

If not it will suck, but you can try pulling the intake off and getting a big sheet of 120 or so grit sand paper and sand it on a table.
There's an idea! The gasket surface (intake side) is a polished surface. I'm sure that is a factor.
If I have to remove the intake, I might as well just Tig weld (or braze) the plate on permanently.

Sent from my PH-1 using Tapatalk


 
 
 
 
 

Related Topics

9 Replies
5114 Views
Last post Dec 19, 2006, 06:05:03 AM
by yotadork83
1 Replies
2226 Views
Last post Jan 20, 2007, 10:13:46 AM
by toyhunter
48 Replies
19854 Views
Last post Nov 30, 2015, 01:11:55 PM
by Kaos III%
23 Replies
8366 Views
Last post May 16, 2013, 10:49:38 PM
by 88_YotaCrawler_88
40 Replies
27443 Views
Last post Apr 04, 2015, 11:20:52 PM
by Jason E.