Author Topic: Toybrota's 22R build  (Read 38170 times)

0 Members and 1 Guest are viewing this topic.

Toybrota

  • Offline 4WD Legend
  • *****
  • Turtle Points: 121
  • Male Posts: 757
  • Member since Dec '15
  • Crawling with Marlin
    • View Profile
    • Buy me some coffee
Re: Toybrota's 22R build
« Reply #210 on: Dec 21, 2018, 05:25:32 PM »
Got this Sucker in today! It is going in my 85' single cab 4x4. New transmission within the last 20K!
First Motor I've installed. At 19 years old it's not impressive, I've known younger that have! It was an interesting process.
Prior to install I did:
Transmission input shaft seal/gasket
Rear main installed/freshly machined flywheel and new clutch kit.

I DIDN'T drop the transmission during the install, Toyota recommends it in the FSM last time I checked.
I got the bell housing and the block lined up and bolted it together pulling both assemblies together.
It wouldn't slide together as I had heavily painted the motor which got on the rear alignment dowels.

I'm really eager to get it going!

Sent from my PH-1 using Tapatalk


 
 
 
 
 

Related Topics

9 Replies
4930 Views
Last post Dec 19, 2006, 06:05:03 AM
by yotadork83
1 Replies
2117 Views
Last post Jan 20, 2007, 10:13:46 AM
by toyhunter
48 Replies
18929 Views
Last post Nov 30, 2015, 01:11:55 PM
by Kaos III%
23 Replies
7987 Views
Last post May 16, 2013, 10:49:38 PM
by 88_YotaCrawler_88
40 Replies
26108 Views
Last post Apr 04, 2015, 11:20:52 PM
by Jason E.