0 Members and 1 Guest are viewing this topic.
toyminator2000 – There has to be dumb people in order for there to be smart people
"what thickness metal u welding with taht setting?"It's the metal scraps from the bed and doors of the Toyota. (don't have any thick stuff to play with yet)I'll check out those sites, and slow down the wire. I'll keep the heat up and spot hit it.Is my gas ok at 10CFH or should it be at 15 or 20?Last question - should I be touching the metal I'm welding with the copper gas shield cover at the tip of the gun, or should it be an inch or so away from the action?Thanks, guys. You rock.
LOCKTUP SHOULD HAVE HIS OWN DISCOVERY CHANNEL SHOW!!
another thing, if this unit also welds with flux core, make sure the polarity is set for gas, inside the welder. Flux core is opposite polarity from solid wire/gas. If it's set wrong, the weld will just lay out on top of the metal(no penetration).
Started by BigMike Chit Chat Camp
Started by BigMike New Announcements and Info
Started by AaronB Chit Chat Camp
Started by 84socal Chit Chat Camp
Started by yotarunner85 Chit Chat Camp