Topic: Double Shackle Design

[MiniSimp]

Ok, I'm designing my final double shackle, can you guys let me know if you see anything wrong with this drawing, need to double check it before it is fabbed.
The shackle is designed to use the factory hanger is the stock position, with 63" Chevy springs.

[BLACKDOG]

    if you are taking that in or fabbing off of that, you may wanna put the degrees of the angles on the piece in the top right corner.   Looks good though, ya wanna do mine next?    

[MiniSimp [OP]]

you may wanna put the degrees of the angles on the piece in the top right corner.

170 deg as shown in the drawing on the left. I'll figure out how much it will cost to make and post it here for ya. If it's cheap, I'll just have 4 made instead of 2.

[awhotrods]

Ok, I'm designing my final double shackle, can you guys let me know if you see anything wrong with this drawing, need to double check it before it is fabbed.
The shackle is designed to use the factory hanger is the stock position, with 63" Chevy springs.

WOW, that looks like it took some time!!

[MiniSimp [OP]]

A little over an hour.

[Hyena]

AUTOCAD?

[MiniSimp [OP]]

yep.