0 Members and 1 Guest are viewing this topic.
I have taken apart most of the hub, but am stuck at the part where you find the torx screw. I seem to have a clutch ring of some sort that I cannot get off. For some reason my situation doesn't seem to add up to what is shown on my haynes manual and on 4x4wire.com. Basically, I'm looking for a step by step with more detailed pictures? I'll try to post pictures tomorrow on what my situation looks like right now.
I've found that I need to get a plate washer, 2 spindle nuts, and one lock washer for each side. Is this correct? And, more importantly, does anyone have Toyota part #'s for these items?
In case anyone else is interested:# 43422-60010 hub Gasket# 43531-60010 hub Gasket# 90214-20007 Flat Washer# 90214-42030 Lock Washer# 90215-42025 Spindle Nut
What is the trick to getting the oil seal off the back of the hub to be able to remove the inner wheel bearing? The FSM manual says pry with a large screwdriver, but brute force is not doing the trick even with a block of wood used as leverage.Anyone know of a trick?
Started by locknload Engine
Started by Kruger10 Newbie Questions
Started by TRACKER Parts Wanted
Started by dan603 Axle/Differential/Steering
Started by memorybox New Member Check-In!