Topic: Extra Cab windows

[85toyextcab]

How do i remove the extra cab windows, what the tips and tricks. Also what the tips and tricks gettin it back in???
Thanks

[jimbo74]

pretty much just pull and push.... to get back in, work it slowly.... some also try to use the rope method, where it holds open one side, and then you can push it through

[Snowtoy]

You remove the 1st gen X-cab windows by pushing them out from the inside, the same way you would do the rear window.

Installation is easiest by using a piece of rope(about 1/8-1/4" thick), and long enough to go all the way around the window w/at least 6 inches left over on each end.  Lubricate up the rope or the track in the rubber molding and place the rope into the track w/the rope ends at the bottom of the window.  Place the window into the opening and while pushing on the window from the outside, pull the strings from the inside.  The strings will pull the seal into the truck and set the window into place.  A second person is useful to hold the window and push in while you pull the strings, but it can be done with just one person.

[drayday55]

dude piece of cake!!!!  just start prying up the rubber from inside slip a Popsicle stick to help if you need to, but you should not, work around and push out.

pouting back is also cake did it by myself with some 1/4 in ch nylon rope and Windex

[junya92toy]

I didnt even need to do that. I have a 92 with pop out ones haha 2 bolts

[85toyextcab [OP]]

Preshate the input