Author Topic: Transfer case dissasembly (Read 3297 times)

mtnmalr · « **on:** Apr 15, 2003, 02:12:47 AM »

I'm currently working on my son's 89 truck, we're going to install gear drive transfer with crawler gears but I can't figure out how to disassemble the gear drive transfer case. Seem's like shifting fork and rod might be problem. Am I suppose to drive the pins out of shifting rods? I have the back part off but can't separate the front from the center. I haven't purchased a manual for this transfer yet and am looking for some help.

trt2 · « **Reply #1 on:** Apr 16, 2003, 04:33:19 AM »

yes, you are going to need to remove those roll pins from the shift rods.

I suggest you buy Marlins gears which come with some directions...

also, its best to have everything there as opposed to tearing it apart, leaving it on the bench for a couple weeks, then coming back to reassemble it all.

have fun!

Brandon · « **Reply #2 on:** Apr 16, 2003, 08:43:49 AM »

http://www.rcrc4x4.com/ProductReviews/Marlin4_7_install/howto.htm

Brandon · « **Reply #3 on:** Apr 16, 2003, 08:44:29 AM »

not sure what the 89 uses, but nearly the same - they aren't much different unless it is a chain drive

mtnmalr · « **Reply #4 on:** Apr 16, 2003, 02:29:30 PM »

Thanks, that helped alot. :thumb:

Author Topic: Transfer case dissasembly (Read 3297 times)

mtnmalr

Transfer case dissasembly

trt2

Re: Transfer case dissasembly

Brandon

Re: Transfer case dissasembly

Brandon

Re: Transfer case dissasembly

mtnmalr [OP]

Re: Transfer case dissasembly

Related Topics