Hey thanks. Yeah Helena, you aren't far...but too far for bearing pressing.
Huh. I got my first clutch from centerforce, and the last two from...dial a clutch? LUK. None of those came with the bearing hub, just the bearings. Actually I don't remember if the centerforce did or not. That was 10 years ago.
Yeah, I've got a pilot bearing pulling tool. I just did this job a couple years, and 10-15,000 miles ago. Pulled the tranny again due to some issues with it. Wasn't even going to replace the clutch...but the figured I would while it was all apart. Then just decided "hey, I've never had bearings go out, and they still have low miles, so..."Stupid, I know, but what's done is done. I had what I needed and was pressed for time, and so I just put in the new clutch and put the tranny back in. Oh well.
Thanks everyone! I'll check my diff and t-case dust shields first, but it looks like the tranny will be getting pulled again before long.
