Got some more work done on the rear bumper yesterday
![](http://www.volcom.rockfrogs.org/rear-bumper/013.JPG)
Trying to get it sitting where we wanted it.
![](http://www.volcom.rockfrogs.org/rear-bumper/014.JPG)
Reciever hitch for a rear tow point
![](http://www.volcom.rockfrogs.org/rear-bumper/015.JPG)
Sometimes you just have to find the "right" combo of stuff to help hold your stuff level
![Green Grin :greengrin:](https://board.marlincrawler.com/Smileys/marlin/greengrin.gif)
![](http://www.volcom.rockfrogs.org/rear-bumper/016.JPG)
Right side tacked, left side getting ready to be tacked
![](http://www.volcom.rockfrogs.org/rear-bumper/017.JPG)
All tacked on
![](http://www.volcom.rockfrogs.org/rear-bumper/018.JPG)
Trimmed the tube in the front to match the rear of the wheelwell.
![](http://www.volcom.rockfrogs.org/rear-bumper/019.JPG)
Here's what the sides will look like.
![](http://www.volcom.rockfrogs.org/rear-bumper/020.JPG)
Here's the rest of the bumper. I'll need to notch and cut them and they'll be ready to weld in.
![](http://www.volcom.rockfrogs.org/rear-bumper/021.JPG)
Another rear bumper pic
![](http://www.volcom.rockfrogs.org/rear-bumper/022.JPG)
Frame tie-in for the front part of the bumper
![](http://www.volcom.rockfrogs.org/rear-bumper/023.JPG)
Used a 1/4" scab plate on the frame.
![](http://www.volcom.rockfrogs.org/rear-bumper/024.JPG)
The hitch pin hole is close to the rear tube but should work
![](http://www.volcom.rockfrogs.org/rear-bumper/025.JPG)
Bumper support tube to rear crossmember. No scab plate needed since the crossmember is 1/4" thick.
![](http://www.volcom.rockfrogs.org/rear-bumper/026.JPG)
Rear reciever hitch tubing welded to crossmember. I'll add a gusset to the bottom.
![](http://www.volcom.rockfrogs.org/rear-bumper/027.JPG)
Side profile of the bumper.