I thought I would post some photos of my progress tonight on my half doors.

I am building these half doors to run door panels.

I dont have access to a large enough of a break to bend a 90* bend so what i did was i welded a strip to the inside of the panel to have a straight edge that the door panel will sit nice and flush against.
I am going to drill holes to install the factory panel clips onto the welded strip so the panel doesnt flop around.

Im going to finish up the first door tomorrow morning.





Getting it all tacked before fully welding it.


Drilled and spot welded the strip to the high points of the door panel.