I basically need some tips on bobbing my bed on a 89 yota ext cab, how much to cut out of the bed, how to get the line straight, what to use to cut the bed, how to weld the bed back perfect, also will the bed still be strong enough to stand on the tail gate once completed? Thank you
first of all you need to deciede what look your goin for you can cut any where from 1 to 16 i took 16 out of my 90 reg cab i wacked the frame right behind the skakels and welded in the crossbar from a tow package for the rear cross member the factory roll pan sits right infront of asin towards the cab of the tow package made my bed almost a perfect square as for the straight line measure in 1/2 inch or so from the taillight cutout in about 3 dif places then either take a thin piece of straight metal and clamp it top and bottom while lined ip with yur marks or run tape if you can get a straight line the metal is best i just used a angle grinder with a cut off wheel and a sawzall sheet metal shears would be awsome but not nessassary then make ur second line the same way as the first but do it before you cut the first line so its straight when you weld it tack it in place then just start tackn away jump around and dont let the metal heat up or it will warp if you have access to welding tape use it to keep the heat from spreading as for stregnth i welded the pass side almost complete and only a few tacks on the drivers side didnt even do any in the bed floor and i can stand or even jump on my tailgate it holds pretty good o and i used a 110v mig pack with fluxcore wire hope tthis helps
goodluck