Topic: Message #843823

[bigheadbenny]

ok, so i took some pictures, both sides, multiple angles. not the best but i think you can see what im working with. there are 2 spacers between the frame brackets and mounts on each side. the long bolts were used because that was the only way i could get a nut on the end to stretch the motor mount out so it would reach the frame.

i will clarify a few things. i did pull a junk motor out of my truck but i decoded the VIN and it was a factory 22re truck, it now has an 86 22re motor in it and i just installed new motor mounts that i ordered for a 1985 22re truck. so it is what it should be from the factory and is a long way from fitting correctly.

DRIVERS SIDE.





PASSENGER SIDE.