De-shimmed and de-spacered the rear axle, re-shimmed it the right way to correct the pinion angle (which is dead-on now), may have to shim the front, patched the right side framerail since it was starting to bubble/rust, pulled out the Subaru seats, discovered more rust on the passenger floor, starting to weld up all the random holes in the floor from previous seats/whatever. After that's fixed I'm going to undercoat inside and get some sound deadener/heat shielding stuff in there. Cutting off the old "sliders" and may be using them as side rails/tie down points for the flatbed. I may get around to putting the bed box on this week sometime too...
![Fingers Crossed :crossed:](https://board.marlincrawler.com/Smileys/marlin/crossed.gif)
school is in session and all that.
>>Dan