I installed an autometer temp gauge and just went to the factory sender next to the thermostat. I can snap a pic for you tomorrow if you want
Ya, if you could. Cause I have two sensors there, just not sure if I take one out if it will effect the computer or not. But yours runs fine huh?
I have also been pondering about this my self and was thinking of a tee in one of the sensor holes or a new hole tap/thread but like many of my "to do things" it's some where under the stack of other half done "to do things"
I was thinking about seeing if my friend could tig weld another threaded bung or something on the thermostat housing if I couldn't figure something out. I was thinking a tee maybe too. But the sensors are pretty long.
