Ok, I got the front suspension done besides the shackles because I am waiting on the 3/4 inch spacers to show up (they were back ordered). I have the axle bolted in, but nothing attached to it. I ran into a few problems:

#1: Shocks- Way too short now. I do have some shocks from the rear of my moms tundra that would work if I had taller shock mounts. Unfortunately, I cannot weld, so talller shock mounts are out of the question. I am not sure what I am going to do about this yet. The stock length shocks that are in there will hinder my flex A LOT.

#2: Brake lines- they are now way too short as well. I will need to be ordering up a set from Marlin sometime soon.

#3: I am afraid my driveshaft may end up being too short, but currently I am not too concerned about it.

Good news is it looks like tyhe flipped j-arm steering will work just fine. Anyways, here are a few pics:


Springs done, Marlin bushings:




Installed: