« on: Sep 15, 2004, 09:48:12 PM »
Hey Marlin,
How could you know if its a L52? Chances are its a L50 since the L52 was not available until 11/1982. The L50 that the truck most likely had does not have a 80mm front bearing but rather a 75mm input bearing, plus it would have a non-sealed output shaft bearing.
BOOM! BIGMIKE IS THE TECH MASTER!!!!!!!
Whattcha got?!
--> BigMike
To wannabe tech master ------
The L52 with the 80 mm front input bearing would of been available on 8/82 and newer trucks for the 83 model year, however, I have seen a name plate above the valve cover that showed the L52 in a 3/82 truck?
The rear main shaft bearing that you refer to as the "non sealed output shaft bearing" was only found on the '81-82 L45 4 speed trans. Although it is still available, it shoud not be used. A sealed bearing will last longer and was used in all L50 and 52 trans.
Check your source before you post
![Ooops! :_oops:](https://board.marlincrawler.com/Smileys/marlin/_oops.gif)
Marlin
« Last Edit: Sep 15, 2004, 11:49:51 PM by BigMike »
![](https://board.marlincrawler.com/Themes/MCI_V3C/images/ip.gif)
Logged
1980 Toyota - 1997 3RZ-FE 2.7l Engine, Turbo R151F 4.31:1, Triple Turbo Marlin Crawler Billet (2.28x4.70x4.70) = 1,148:1 Crawl Ratio, Marlin Crawler Twin Stick and Short Throw Shift Kits, 30mm H/D Output Shaft, High Angle Drive Lines, 5.29:1, ARBs, High Pinion Front, 25mm HD Billet High Steer Kit, 6 Pin Locking Hub Bodies, 86+ Wide Rear End, V6 3rd member, Chromolly Axles all around, 37" IROKs with Beadlocks, York onboard air - Rollbar air tank, Premier Power Welder, Marlin Crawler 4" USA-made Leaf Springs, Bilstein Shocks, et cetera....