this is the order i go for trail replacement of birfs.
undo dial bolts and pull dial off.
undo c-clip on end of axle.
if brake lines are not long enough, remove caliper (2 bolts)
undo top steering arm nuts, pull out cone washers and remove steering arm.
remove backing plate bolts (for wiper seals)
lift up slightly on knuckle and rotate down.
whole knuckle should come off as a unit.
then remove birf and axle.
if you get good at this you can change a birf in a 1/2 hour.
or a third member pretty fast.

derek