Worked on it all day today. Went and bought some mandrel 2 1/4 ulumanized bends and a stick of exhaust tubing. It took most of the day building the first few feet with the y pipe. Ended up looking pretty good and sounds a lot diffirent now too. I used the same muffler (flowmaster) as was on it before. Before it had a million bends and turns , and the y pipe was more of a T pipe. Now everything is radiused and runs nice and staight It fit between the floor board and the skid plate with a quarter inch gap above and below. It runs all the way to the back and exits just inside the driver side shackle with a chrome tip for bliing factor. I wil probably wrap the exhaust. Where is a cheap place to get that wrap? Is it worth it?
I will post up some pics of the exhaust tomorrow. Hope fully also get the floor board repaired and seat brackets built, along with a nice center console