FFC: I'm kinda new to the 'crawler croud'
and this thread and after readin ALL THE WAY THRU
,I must say that I'm pretty impressed :bowdown:w' the 'Miga build up
.A couple o' points
#1 how 'bout a "comp cut" to the rear fenders to allow a MUCH greater wheel base
and a less severe driveline angle?
(I KNOW 'bout the COST factor
,bit a new vehicle to replace the roll ravaged one seems MORE of a waste!)
#2 I think some of the previously drawn in ideas
(stinger) would have made fer a better bumper design,but maybe youse can grind the lower pipe stubs flat,bend some smaller diameter tube and insert(did he say insert?) it into the HOLE
and burn it
to the bottom of the upper tube just fer a start. I AM pretty artistic(autistic?) and could prob'ly draw up some designs to finish out the bumper,but I don't do computer to good :willynilly:and I don't have a scanner :rivers:so you'll hafta depend on yer friends in Cali an' AZ to help ya there. Of course, I guess yuh cood tell me ta kiss yer
,but that wooden bee LADY-like,woodit? Oh,yeah...and don' ferget ta tie some braces(bumper)in to that chunk o' square tube up front! Yuh already stood it on the rear,how long before the front?