Pages: [1]   Go Down
 
Print
 

Author Topic: problem after making square front drive shaft  (Read 2106 times)

0 Members and 1 Guest are viewing this topic.

phi564

  • Offline Rock Crawl'n
  • **
  • Turtle Points: -12
  • Male Posts: 54
    • Member since Jul '05
  • Crawlin in KY
    • View Profile
    • high clearance offroad
Re: problem after making square front drive shaft
« on: Aug 14, 2007, 11:34:52 AM »
the joint does not have enough angle.

i'm gonna got cut one end of a rear shaft i have and just eliminate the CV, just run normal u-joints on both ends.
Logged
01 Dodge 2500 Cummins dd/ tow rig
'90 toyota w/ 4.3 on propane/th350/toy duels
fj80 axles, 39" BFG krawlers, psc full hydro, 4.10's, detroit front, welderd rear



It's better to ask for forgiveness than permission
Pages: [1]   Go Up
 
Print
 
 
 
 

Related Topics
13 Replies
2778 Views 		Last post Jul 03, 2004, 10:35:17 AM
by WHITE_TRASH
19 Replies
2244 Views 		Last post Jun 17, 2007, 12:34:03 PM
by JoeShmo65
10 Replies
3182 Views 		Last post Oct 29, 2007, 04:45:59 AM
by trax28to
7 Replies
2203 Views 		Last post Jun 18, 2009, 12:53:44 PM
by 86rustbucket
8 Replies
4395 Views 		Last post Jan 25, 2010, 08:48:40 AM
by AZ 4X4