« on: Mar 11, 2004, 12:35:25 AM »
Make sure when you call to tell them that i posted to you on the board.
Do you have the front nose cose and shifter handle base?
There is also a two piece shifter socket linkage assm that goes inside the tail housing.
I can ship these parts out tomorrow.
You will note that your trans was assembled using silicon from the factory.
Talk to you tomorrow
Marlin
« Last Edit: Mar 11, 2004, 12:36:04 AM by Marlin »
Logged
1980 Toyota - 1997 3RZ-FE 2.7l Engine, Turbo R151F 4.31:1, Triple Turbo Marlin Crawler Billet (2.28x4.70x4.70) = 1,148:1 Crawl Ratio, Marlin Crawler Twin Stick and Short Throw Shift Kits, 30mm H/D Output Shaft, High Angle Drive Lines, 5.29:1, ARBs, High Pinion Front, 25mm HD Billet High Steer Kit, 6 Pin Locking Hub Bodies, 86+ Wide Rear End, V6 3rd member, Chromolly Axles all around, 37" IROKs with Beadlocks, York onboard air - Rollbar air tank, Premier Power Welder, Marlin Crawler 4" USA-made Leaf Springs, Bilstein Shocks, et cetera....
