well I spent yet another 500 on the beast today, got my flip kits and rock sliders comming from marlin, and I found the add a leafs on
www.suspensionconnection.com for 45.00 a set so I got 2 pair of those comming as well, get this the 2" and the 3" were the same price.... the 2" were short and flat, I didn't thing that would give me much lift, but the 3" were long and had quite an impressive arch, so if you haven't guessed yet I got the 3" add a leafs for all four corners, like I said before if its going to be a little to high it might as well be a lot to high,
also had a bit of luck today I got another solid axle I'm not sure what it is yet but it has open knuckles and ball joints, right hand drive the ball joints tell me that it's a ford axle but the right drive is strange because most all fords with solid axles have left drive, got to show it to the 4xguru he will know exactly what it is, I'm thinking Dana 44 or 50
got my inclinometer in today, that was a steal on ebay 75 + 13 s/h and it came packed in a dash mat that wasn't even mentioned in the auction, and it's grey to boot
also got my vented rotors another steal on ebay, get this
www.jtoutfitters.com sells the pair for 80.00 on thier site.... had them listed for 49.95 starting bid 18.53 s/h but that don't count so I'm thinking why in the hell should I pay 80 when I could get them for 50 duh.... nobody else bid
my boss has submitted the paper work for my bonus so that should be here in about spring.... I'm thinking marlin 4:88 electric locker for the rear