Pages: [1]   Go Down
 
Print
 

Author Topic: Constructing a square tube D-shaft  (Read 2472 times)

0 Members and 3 Guests are viewing this topic.

snorklehead

  • Offline Rock Crawl'n
  • **
  • Turtle Points: 0
  • Posts: 103
    • Member since Dec '02
  • non-crawler clutch-burner
    • View Profile
Re:Constructing a square tube D-shaft
« on: Jul 04, 2003, 02:15:31 PM »
I've seen the tube butt welded on the front d-shaft. Never seen the square mated to the round..that might work too and you might even keep the balance a little better than using all square tube.
Logged
The beatings will continue till morale improves
Pages: [1]   Go Up
 
Print
 
 
 
 

Related Topics
5 Replies
2645 Views 		Last post May 06, 2005, 12:19:15 AM
by 4DEES
8 Replies
5568 Views 		Last post Sep 04, 2006, 08:51:54 PM
by Rockdiver
2 Replies
1269 Views 		Last post Jan 23, 2009, 05:03:40 PM
by Steve_925
0 Replies
919 Views 		Last post Feb 09, 2009, 05:36:07 PM
by studentwheeler
7 Replies
2249 Views 		Last post Jun 18, 2009, 12:53:44 PM
by 86rustbucket