I cleaned off the operating table when I got home so I could start making my custom transfercase. I picked up a couple complete cases and found a couple that were for parts only. The objective here is to get a lower rear output to correct my driveshaft angle problem so I can get rid of the high pinion rear and go V6 third.
is there a way to possibly make an off-set Toy transfer case work, then clock it down a little bit, so you can bolt it up to your low-pinion V6 third?
![I Dunno... :dunno:](https://board.marlincrawler.com/Smileys/marlin/dunno.gif)
just a suggestion, don't know how feasible it is....