Got the gears and spool set in the rear. Ended up cutting out new shock tabs got them squared up and burned in. Going to wait on putting the u-bolt eliminator kit on until I figure on If I want to flat belly or not so I can fine tune my pinion angle later down the road. Technically it is Mechanically all set once I throw the shafts in and get the rear disk set up on. Still need to get my stuff ordered from surplus center for my hydro assist. Going to clean up the wiring from the swap and start on the creature comforts and hopefully take it out and get a shake down run done.
Sent from my iPhone using Tapatalk