...I think I was at 82cc
.060 over size bore 90mm stroke, (custom cut done when I had money)
I'm kinda kick'n myself for not going more than .020" on the over bore! A few more cc's would have been better?? There's no substitute for cubic inches!.... Go BIG!
![Willy Nilly :willynilly:](https://board.marlincrawler.com/Smileys/marlin/willynilly.gif)
Size matters!
![Gap :gap:](https://board.marlincrawler.com/Smileys/marlin/gap.gif)
There's no such thing as too much money, too much fun, or too much torque!!
![Rocking Out :rockingout:](https://board.marlincrawler.com/Smileys/marlin/rockingout.gif)
Gnarls.
![Spin :spin:](https://board.marlincrawler.com/Smileys/marlin/spin.gif)